Rimage AutoEverest AutoPrinter Guia do Utilizador descarregar pdf (Página 14)

Rimage AutoPrinter™ User Guide

10 110656_I

b. If the disc is not centered on the print

pad, align the printer side to side.

i. Using the T25 Torx screwdriver,

loosen the two side to side

alignment screws.

ii. Slide the printer, not the printer

tray, until the side edges of the

disc and printer pad are aligned.

iii. Tighten the two side to side

alignment screws.

Side to Side Alignment Screws

Front to Back

Alignment Screw

c. Using either a T25 Torx driver or a

5/32” Allen wrench, turn the front to

back alignment screw until the disc

hangs over the edge of the print pad by

0.010” – 0.015” (0.25mm – 0.38mm).

Print Pad

5. When the printer is aligned, slide the lift arm to the top the unit.

6. Press the printer button to close the printer tray.

7. Press the disc release button to release the disc from the gripper.

# Tip: Place your hand under the disc to catch it.

1 2 ... 9 10 11 12 13 14 15 16 17

Sem comentários

Rimage AutoEverest AutoPrinter Guia do Utilizador Página 14