Rimage DLN5200 Guia do Utilizador descarregar pdf (Página 18)

Rimage DL5200/DLN5200 User Guide

c. Manually rotate the lead screw

counterclockwise to move the lift arm

down to the print pad.

Print Pad

Lead Screw

3. Check the disc alignment.

To see if the disc is centered, observe the

gap between the edge of the disc and the

raised edges as shown by the arrows.

If the disc requires side to side alignment,

continue to step 4.

If the disc requires front to back alignment,

continue to step 5.

4. If necessary, perform a side to side

alignment.

a. Loosen the two side to side alignment

screws.

b. Slide the printer until the side gaps are

equal.

- Important! Slide the entire printer,

not the printer tray.

c. Tighten the two side to side alignment

screws.

5. If necessary, perform a front to back

alignment.

a. Turn the front to back alignment screw

until there is a 1/16” (1.5mm) gap

between the front edge of the disc and

the raised edge of the disc retainer.

 Tip: You can use the Torx T25

driver, or 5/32” Allen wrench, to turn

the front to back alignment screw.

Front to Back Alignment Screw

Side to Side Alignment Screws

Disc Retainer

Gap Distance

16 110768_F

1 2 ... 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários